Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
alarm in wind vane mode i-70
02-10-17, 03:42 PM
Post: #1
alarm in wind vane mode i-70
I have an i-70 system and often use to steer in wind vane mode, which works well.....except for an alarm that goes off for wind direction change. It appears to be set at about 10 degrees, which means in variable winds (or when the boat is rolling hard) the alarm is continuously going off. Since I often open water solo, this is my preferred mode so I can sleep, but with an alarm going off every 5 minutes its a pain.
Is there a way to expand the gate or turn off?
Thanks
Dan
Find all posts by this user
Quote this message in a reply
02-14-17, 05:04 PM (This post was last modified: 02-17-17 12:34 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: alarm in wind vane mode i-70
Welcome to the Raymarine Forum Dan,

Unfortunately, the software of Raymarine autopilots does not presently support configuration of the wind shift alarm threshold threshold. A feature request will be logged accordingly to consider this feature for inclusion within a future software update to the Evolution autopilots as well as to future autopilot designs.

Please click here more information concerning product and feature suggestions.
Visit this user's website Find all posts by this user
Quote this message in a reply
01-22-18, 04:20 PM (This post was last modified: 01-23-18 10:21 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: alarm in wind vane mode i-70
Any update on the status of this request?
Find all posts by this user
Quote this message in a reply
01-23-18, 10:21 AM
Post: #4
RE: alarm in wind vane mode i-70
Dan,

Software feature additions are listed within the software update history table of each product's [url=http://www.raymarine.com/display/?id=797]software update web page[/url. With respect to the suggested feature, it is not yet been implemented.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us