Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connecting CP200 to my mfd
02-15-17, 05:30 PM (This post was last modified: 02-16-17 12:52 PM by Chuck - Raymarine - Moderator.)
Post: #1
Connecting CP200 to my mfd
I assume I go from the CP200 to my mfd with a raynet to raynet cable? Or do I link it in on my nmea 2000 network using a raynet to seatalk and then to nmea?
Find all posts by this user
Quote this message in a reply
02-16-17, 12:50 PM
Post: #2
RE: Power cable
riverrat42701,

The CP200 and a/c/e/eS/gS-Series MFDs both feature Ethernet communications interfaces to support communications between these two devices. Accordingly, the CP200 would be interfaced to the Ethernet NETWORK socket of the a/c/e/eS/gS-Series MFD or HS5 RayNet Network Switch (should one be installed onboard) via an appropriate length of RayNet (F) to RayNet (F) Cable.
Visit this user's website Find all posts by this user
Quote this message in a reply
02-19-17, 06:39 AM (This post was last modified: 02-21-17 01:52 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: Connecting CP200 to my mfd
Thank you for the response Chuck. One more question, can I link My es98 to my a65 using that same type cable? Will I be able to view the sonar data that is hooked into the es98 on my a65 with the raynet Ethernet connection?

Thank you
Find all posts by this user
Quote this message in a reply
02-21-17, 01:56 PM
Post: #4
RE: Connecting CP200 to my mfd
riverrat42701,

Q1: Can I link My es98 to my a65 using that same type cable?
A1: Yes. As with the CP200, the a65 MFD would be interfaced to the remaining Ethernet NETWORK socket of the eS98 MFD or to a HS5 RayNet Network Switch (should one be installed onboard) that the eS98 MFD has been interfaced via an appropriate length of RayNet (F) to RayNet (F) Cable.

Q2: Will I be able to view the sonar data that is hooked into the es98 on my a65 with the raynet Ethernet connection?
A2: Yes
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us