Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
fuse requirement
04-15-17, 09:58 PM
Post: #1
fuse requirement
Chuck , I have a E120 with a 5S open array radar . The E120 manual says to refer to scanner handbook for fuse size for the display . I could not find that info there . Could you tell me how many amp fuse I should use ? Thanks , Jim
Find all posts by this user
Quote this message in a reply
04-18-17, 01:13 PM
Post: #2
RE: fuse requirement
Welcome to the Raymarine Forum Jim,

While the C/E-Series MFDs were designed to supply power to radomes, then were not designed to power open array pedestal. The latter should be powered by a dedicated power circuit which has been protected with a 20A fuse or 15A breaker when powered by a 12V system. Should the MFD not be interfaced to a radome, then its power circuit may be protected with a 6.3A fuse or 5A breaker.
Visit this user's website Find all posts by this user
Quote this message in a reply
04-18-17, 05:52 PM (This post was last modified: 04-19-17 09:11 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: fuse requirement
Chuck , thanks for the reply and clarification on that . the manual just says radar scanner not radome . when you explained it , it makes sense . thanks again , Jim
Find all posts by this user
Quote this message in a reply
04-19-17, 09:11 AM
Post: #4
RE: fuse requirement
You're welcome.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us