Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Radar cable resistance test
04-20-17, 09:45 AM
Post: #6
RE: Radar cable resistance test
iimatias,

Per my last response, the A80272 RayNet (M) to SeaTalkhs (M) Adapter Cable would be used if the MFD's SeaTalkhs socket was vacant. This would not be the case for systems in which a SeaTalkhs Network Switch had been installed onboard. Should a SeaTalkhs Network Switch be installed onboard, then an assembly constructed from an A80162 RayNet (M) to RayNet (M) Cable Joiner and an an appropriate length of RayNet (F) to RJ45 (M) Cable would be used to adapt the Digital Radar Cable to be mated to a RJ45 (F) socket of the SeaTalkhs Network Switch.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Radar cable resistance test - iimatias - 04-19-17, 10:28 AM
RE: Radar cable resistance test - Chuck - Raymarine - Moderator - 04-20-17 09:45 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us