Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
HD Digital open array not rotating
05-22-17, 08:42 PM
Post: #1
HD Digital open array not rotating
I am troubleshooting a 4KW HD Digital 4' open array. Initially the VCM would not come out of sleep mode. The core was sent to Raymarine, a minor issue noted and repaired, and it was re-installed. The problem persisted but intermittently. The cable was then replaced. The unit is now seen on the network and can be activated, however the scanner rotates only a couple turns before stopping and displaying a message of no rotation. If turned by hand, the scanner turns freely and there is no visible issue with the belts or drive assembly.

As an FYI, the boat is plugged into shore power with chargers running and the batteries are fully charged.
Find all posts by this user
Quote this message in a reply
05-24-17, 01:31 PM
Post: #2
RE: HD Digital open array not rotating
Welcome to the Raymarine Forum zelatore,

Given the symptoms reported within a system having fully charged batteries and while still connected to shore power, it appears that circuitry within the radar core responsible to detection of antenna rotation has failed. It is recommended that the radar core be removed from the radar pedestal and that it then be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)