Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST2000+ broken gaskets
08-26-17, 08:39 AM
Post: #1
ST2000+ broken gaskets
I found some broken gasket parts inside our ST2000+.
Is one of them from the pushrods exit end of the unit?
Appears as though the other one might be a bushing from behind the largest gear on the belt/gear arrangement?
Are these parts available?
The unit was failing due to these parts falling underneath the internal compass gimbal, restricting its movement.
Find all posts by this user
Quote this message in a reply
08-28-17, 03:59 PM
Post: #2
RE: ST2000+ broken gaskets
Welcome to the Raymarine Forum Maluhia,

Raymarine does not consider the ST2000+ to be an end user repairable item. Accordingly, internal parts and repair instructions are not available. It is recommended that the ST2000+ be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Visit this user's website Find all posts by this user
Quote this message in a reply
08-29-17, 02:48 PM (This post was last modified: 08-29-17 04:19 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: ST2000+ broken gaskets
Thanks Chuck.
Removed gasket shrapnel, unit tested o.k. in 5 foot waves and 18-20 kits of wind in AUTOmfor an hour or so. It did experience a power interruption, but immediately turned back on in STANDBY mode. (it was powering off before after a few minutes of use, and not coming back on)
Find all posts by this user
Quote this message in a reply
08-29-17, 04:19 PM
Post: #4
RE: ST2000+ broken gaskets
You're welcome.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us