Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Footprint of p70s vs ST5000+ control head
01-25-18, 04:59 PM (This post was last modified: 01-26-18 08:58 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Footprint of p70s vs ST5000+ control head
I am upgrading my ST5000+ autohelm using the existing Type 1 drive but adding the Evolution ACU-200 sailboat pack with p70s control head. Will the new p70s control head fit in the same cut out on the navpod as the old ST5000+ control head?
Find all posts by this user
Quote this message in a reply
01-26-18, 09:07 AM (This post was last modified: 01-26-18 09:10 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] Footprint of p70s vs ST5000+ control head
Welcome to the Raymarine Forum Bill,

The footprint of a p70/p70S/p70R/p70RS autopilot control head is virtually identical to that of the ST5000+. The circular cut-out of the i70S/p70S/p70RS is the same as that of the ST5000+. The i70S/p70S/p70RS installation template may be found here.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)