Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom Auto Track
03-14-18, 09:23 AM (This post was last modified: 03-14-18 02:51 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Axiom Auto Track
I recently upgraded to 3.3.170. I have "auto track" turned on. It seems since upgrading to this build I get a track point inserted before the GPS has a valid LAT/LON, hence everytime I turn off and then on my MFD i get a wild point to LAT/LON=0 in my track file. Is it something I turned on or did a coder take out the valid LAT/LON check? Thanks much, Anthony
Find all posts by this user
Quote this message in a reply
03-14-18, 02:51 PM (This post was last modified: 03-14-18 02:52 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] Axiom Auto Track
Welcome to the Raymarine Forum Anthony,

This behavior has indeed been present since outset. To avoid this behavior, it is recommended that the day's track be stopped and then saved (if of value) prior to shutting down the equipment at the end of the day. However, as a result of this report, feature change request will be submitted to not create track points whenever the system has either not acquired a GPS position or the GPS sensing device loses its position FIX.

Please click here more information concerning feature suggestions.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)