The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Possible CPT-200 Transducer Low Voltage Issue
03-19-18, 08:06 AM (This post was last modified: 03-19-18 10:23 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Possible CPT-200 Transducer Low Voltage Issue
This post is being made to inquire if a low transducer voltage alert message at startup of a CP-200 sounder module / CPT-200 transducer should be a concern. For approximately 60 second after start-up my multi-function display (MFD) shows a low transducer voltage alert message while at the same time the CPT-200 LED indicator flashes the five amber alert for low voltage alert.

After 60 seconds passes, the alert message disappears, the CPT-200 LED flashes normal operation green, and the MFD shows a normal transducer display (note this is a new installation on land and has not been water tested yet). Voltage at a switch serving the CPT-200 of 12.77 volts was measured more than 60 seconds after startup. “Round-trip” wiring is less than 20 feet with 12 AWG wire.

The question is should this short alert message be a concern or is this a normal message at start-up.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Possible CPT-200 Transducer Low Voltage Issue - chartertom - 03-19-18 08:06 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)