Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST1 to STNG Converter
04-17-18, 03:13 PM
Post: #1
Star ST1 to STNG Converter
I purchased an Axiom 9 and Quantum radar to replace an older (dead) non-Raymarine Chartplotter/Radar. I wanted to network the new MFD with my existing Seatalk instruments. The Axiom 9 is connected to the ST1STNG device with a NMEA 2000 to STNG adapter cable and the ST4000+ Autopilot connected with a Seatalk adapter cable with the red wire cut and insulated. I discovered after days of testing that the power on sequence was critical. The Axiom and the ST4000+ have to be on prior to power being applied to the ST1STNG converter. I was unable to determine this from the manuals, this forum, the internet at large, or Raymarine Technical support. My goal is by posting this I will save someone else the days of testing I spent trying to learn this.
Find all posts by this user
Quote this message in a reply
04-19-18, 03:51 PM
Post: #2
RE: ST1 to STNG Converter
Welcome to the Raymarine Forum svRedSkies,

Thanks for sharing your experience.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us