Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] Axiom 7 with Rv-100 transducer.
09-20-19, 08:05 AM
Post: #11
RE: [DG] Axiom 7 with Rv-100 transducer.
Hi ystaspinar

The link you advised

shown here is for the E66054 P66 transducer and is the correct transom mount transducer.

Just to clarify, the P66 is a generic name for the style and ceramic used in these transom mount transducer, it is essential to use the correct variant since they are all wired differently for different manufacturers and different applications.

In this case, the E66054 is the correct variant.

Regards

Derek
Find all posts by this user
Quote this message in a reply
09-20-19, 08:12 AM
Post: #12
RE: [DG] Axiom 7 with Rv-100 transducer.
Hi ystaspinar

The correct Y Cable to use with the AXIOM RV, the E66054 P66 style TX and the A80464 RV100 transducer is the A80492. Please note that in this configuraiton, there is no conical sounder operation from the RV100 transducer, since the Airmar E66054 is connected and also nte that the maximum power from the Airmar transducer is only 600W.

If you do not wish to use the RV100, then you will only need an A80489 adapter cable to connect the E66054 P66 to the AXIOM RV. Note the E66054 P66 will still only ping at 600W

Regards

Derek
Find all posts by this user
Quote this message in a reply
09-21-19, 03:11 PM
Post: #13
RE: [DG] Axiom 7 with Rv-100 transducer.
Thank you dear Derek for your asistance, ı ordered P66 ducer and A80489 adapter cable. I will write my opinions soon.
Best regards.
Yavuz
Find all posts by this user
Quote this message in a reply
09-23-19, 07:52 AM (This post was last modified: 09-23-19 07:52 AM by Derek - Raymarine - Moderator.)
Post: #14
RE: [DG] Axiom 7 with Rv-100 transducer.
Hi ystaspinar

Your'e welcome

Thanks
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)