Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom 7 Surface Install
04-24-18, 10:07 PM (This post was last modified: 04-27-18 08:47 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Axiom 7 Surface Install
Hi Support,

I have an Axiom 7 screen going into my console as a surface install. Would the included back surface cover or the rear mounting brackets be the best option? I currently have the included cover but was curious why there is another type of rear mounting bracket available?

Also would any marine sealant be necessary for between the front of the screen against the console or is the included foam seal all that is needed?

Thank you for your assistance.
Find all posts by this user
Quote this message in a reply
04-26-18, 03:02 PM (This post was last modified: 04-27-18 08:47 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] Axiom 7 Surface Install
Welcome to the Raymarine Forum Solo_Cam21,

Please see the diagram below. If installing per option 3 (Surface Mount), then Axiom 7's package should contain all that is needed. Raymarine only recommends using the supplied gaskets to seal MFDs to a helm.

[Image: attachment.php?aid=1685]
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)