(DG11) ST60+ wind speed
|
06-08-18, 01:47 AM
(This post was last modified: 06-08-18 06:25 AM by Derek - Raymarine - Moderator.)
Post: #3
|
|||
|
|||
RE: (DG11) ST60+ wind speed
Thank you very much for the response. Thank you.
Apologize for delay, but had to depart on crossing: Could have used that damned wind info! Pins at masthead clean and intact according to my-wife-the-mastclimber: I trust her assessment. Continuity check with wire ends 70 feet apart seems difficult! Ideas? Cable in mast conduit so not accessible, but no damage to my knowledge. Too long since I installed r28170 so have forgotten how cable wires are connected to transducer base, but will download a manual. Like me, then, you think the r28170 and ST60 display are OK, right? I have two segments of cable to test, then: display to junction box and junction box to masthead. Again, thank you very much. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
(DG11) ST60+ wind speed - Wings - 05-22-18, 10:44 PM
RE: (DG11) ST60+ wind speed - Derek - Raymarine - Moderator - 05-24-18, 06:30 AM
RE: (DG11) ST60+ wind speed - Wings - 06-08-18 01:47 AM
RE: (DG11) ST60+ wind speed - Derek - Raymarine - Moderator - 06-08-18, 06:31 AM
RE: (DG11) ST60+ wind speed - Wings - 06-08-18, 01:55 PM
RE: (DG11) ST60+ wind speed - Derek - Raymarine - Moderator - 06-11-18, 08:51 AM
|
User(s) browsing this thread: 1 Guest(s)