(DG11) ST60+ wind speed

[Derek - Raymarine - Moderator]

Hi Wings,

If you can get the masthead Tx down to the deck,then you could get a 5 pin DIN plug, strip off the outer housing and make up a short cable to plug into the back of the ST60 display, the masthead unit will plug directly into the 5 pin DIN plug.

See here for the pin assignments

This will confirm immediately if the display and the transducer are OK, if they are, then by a process of elimination, you can confirm the cable through the boat tothe bottom of the mast is OK - this then just leaves the cable up the mast and the mast block- which would need to be replaced complete anyway.

I hope this helps?
regards
Derek