Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] T120 Wind Transducer lost signal
06-04-18, 09:06 AM (This post was last modified: 06-07-18 02:56 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] T120 Wind Transducer lost signal
In the diagnostics section of the wireless instrument I found the diagnostic section and checked the level. It was at a 5 most of the time but don't know if that is good or bad. We lose data from the T120 occasionally and have reboot the t111 master to get signal back.
Find all posts by this user
Quote this message in a reply
06-07-18, 03:12 PM
Post: #2
RE: [CA11] T120 Wind Transducer lost signal
Welcome to the Raymarine Forum sthomason,

The most common cause for the reported problem is low battery level(s) within the components. It is recommended that the hull transmitted be permitted to charge overnight and that the system then be tested again. Should the problem persist and should more than one display is located onboard the vessel, then it would be recommended that display which is closest to the T120 be configured as the master. Should the problem persist thereafter, then the please indicate whether the vessel features structures which have been constructed from carbon fiber and/or sails which have fabricated from kevlar.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us