Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] RS150 STNG connection failure
06-18-18, 01:41 PM
Post: #6
RE: [CA11] RS150 STNG connection failure
Edward,

Per our phone conversation today, it is recommended that the resistance across the CAN_H and CAN_L pins within the termination plugs be verified to be 120 Ohms and that they be replaced if found to not be so. Please click here to view a FAQ addressing the pin-outs for the SeaTalkng networking components.

It is recommended that the compressed software update folder containing LightHouse 3 for Axiom MFDs be downloaded to your computer and that its contents then be extracted into the root level directory of a microSD memory card. This process is detailed below:
Software update procedure:
1) Insert your microSD memory card into your computer's memory card reader
2) Download the desired software update compressed folder from the LightHouse 3 for Axiom & Axiom Pro MFDs software update web page. The compressed folder containing the software update files will be downloaded from the product's software update web page and saved on the computer used to download the software update zip file ... the downloaded file will typically be located within the Downloads folder of computers running the Windows operating system
3) Open the computer's Downloads folder (or your computer's folder where downloaded files are saved)
4) Right click on the downloaded compressed folder containing the software update files to display a menu of options
5) Left click on the EXTRACT ALL menu option to display the Extract Compressed (zipped) Folders dialog
6) Left click on the Browse button within the Extract Compressed (zipped) Folders dialog to display the Select a Destination dialog
7) Within the Select a Destination dialog, left click on the drive letter corresponding to your microSD memory card, and then click on the OK button.
8) After all files have been extracted, remove the microSD memory card containing the software update files from the computer's memory card reader
9) Power the system's MFDs ON, permit them all to complete startup initialization, and then acknowledge the Limitations of Use notice.
10) Insert the microSD memory card containing the software update files into the Data Master MFD's memory card reader
11) Command the Data Master MFD to Update Software (HOME->SET-UP->GETTING STARTED->UPDATE SOFTWARE) and then to Check SD Card
12) When provided a list of products for which software updates are available, select to update only the software within the Axiom MFDs. The Data Master MFD will push the software update out to the system's other MFDs
13) After updating the software within the MFDs, command the Data Master MFD to Update Software (HOME->SET-UP->GETTING STARTED->UPDATE SOFTWARE) and then to Check SD Card
14) When provided a list of products for which software updates are available, select to update only the software within the EV-1 CCU***.
13) After updating the software within the EV-1 CCU, command the Data Master MFD to Update Software (HOME->SET-UP->GETTING STARTED->UPDATE SOFTWARE) and then to Check SD Card
14) When provided a list of products for which software updates are available, select to update the software within the remaining components of your system for which software updates are available.

As noted during our conversation, following software updates to an Evolution autopilot, it is recommended that the Pilot Factory Reset be executed, Dockside Wizard be executed, and that the vessel again be taken out to "Detect Magnetics". Please click here to view a FAQ addressing this subject.


*** You must update EV1 CCU's software before updating your ACU.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] RS150 STNG connection failure - Chuck - Raymarine - Moderator - 06-18-18 01:41 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us