Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] A68 copy routes - markers from iOS app to unit
06-21-18, 10:15 AM (This post was last modified: 06-29-18 10:02 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] A68 copy routes - markers from iOS app to unit
Have the latest lighthouse firmware and latest navionics card installed in plotter

When phone connected to plotter and sync completed I can see the routes/markers I want to transfer in the plotter card archive folder.

When I tap to copy the data I get an error message that the card is in use and nothing transfers

what am I doing wrong?

Thanks

Mike

A68
Cruising the Chesapeake Bay
Find all posts by this user
Quote this message in a reply
06-29-18, 10:11 AM
Post: #2
RE: [CA11] A68 copy routes - markers from iOS app to unit
Welcome to the Raymarine Forum Mike,

Please verify that the MFD has been updated with LightHouse II v19.03 software. Given the symptom reported, it is recommended that the Navionics Boating app be shut down on the mobile device. If the problem persists after doing so, then please attach the problematic GPX file(s) to your response to permit us to duplicate the reported problem.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)