Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] 2nd transducer with the axiom 9
04-23-19, 08:59 PM (This post was last modified: 04-25-19 02:41 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] 2nd transducer with the axiom 9
Hi Guys, I just recently installed s new axiom 9 on my seacraft. I m using the RV 100. Like others I’m not able to hold bottom over 8knts. What is everyone running for a secondary 50/200 transom mount transducer? Any suggestions would be greatly appreciated.
Find all posts by this user
Quote this message in a reply
04-25-19, 02:49 PM
Post: #2
RE: [CA11] 2nd transducer with the axiom 9
Welcome to the Raymarine Forum Gnj5,

If seeking a transom mounted transducer would typically be recommended that either the A102138 P58 or E66054 P66 transducers be used for such purposes. For those having solid fiberglass hulls no thicker than 5/8" who may be seeking an in-hull transducer for such purposes, the E66073 P74 or the E66008 P79 transducers are often used for such purposes. If selecting the P58 or P74 transducer, then the A80491 Y-Cable would be used. Alternatively, if selecting the P66 or P79 transducer, hen the A80492 Y-Cable would be used.
Find all posts by this user
Quote this message in a reply
04-25-19, 04:50 PM
Post: #3
RE: [CA11] 2nd transducer with the axiom 9
Chuck, Thanks for the response. I think I’ll give the P66 a shot.
Find all posts by this user
Quote this message in a reply
04-26-19, 08:23 AM
Post: #4
RE: [CA11] 2nd transducer with the axiom 9
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)