Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Installation problem routing the GPS cable AIS 700
06-28-18, 10:23 AM (This post was last modified: 06-28-18 03:34 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Installation problem routing the GPS cable AIS 700
I am unable to route the cable of the GPS unit that comes with the AIS 700 due to the size of the connector. Can I cut the RG 58 cable and install a new connector.

Thanks for your help
Find all posts by this user
Quote this message in a reply
06-28-18, 10:58 AM (This post was last modified: 06-28-18 03:34 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Installation problem routing the GPS cable AIS 700
Welcome to the Raymarine Forum epc7405,

Raymarine recommends that the cables of any passive GPS antennas for its products not be modified. However, if you should find it necessary to do so, then care should be taken to ensure that the antenna's cable is not shortened and that the TNC connector is properly installed.
Visit this user's website Find all posts by this user
Quote this message in a reply
06-28-18, 04:41 PM (This post was last modified: 06-28-18 07:39 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] Installation problem routing the GPS cable AIS 700
Thank you...
Find all posts by this user
Quote this message in a reply
06-29-18, 08:11 AM
Post: #4
RE: [CA11] Installation problem routing the GPS cable AIS 700
You're welcome.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us