Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] Spanning Tree (STP)
07-24-18, 07:43 AM (This post was last modified: 07-27-18 12:58 AM by Tom - Raymarine - Moderator.)
Post: #1
Spanning Tree (STP)
Do Raymarine MFD’s support spanning tree (STP)?

I have two MFDs which I’d like to connect to each other directly, but also both to the Ethernet switch (third-party with STP support) with their second Ethernet ports. This creates a redundant physical network, but if the MFDs don’t support STP it could create a loop. I am assuming each Ethernet port on the MFDs is a part of a virtual switch and not an interface (i.e. the MFD only has one IP address, not one for each Ethernet port).

Thanks!
Find all posts by this user
Quote this message in a reply
07-27-18, 01:04 AM
Post: #2
RE: Spanning Tree (STP)
Hello swamplynx,

The MFDs do indeed each have a single IP. I don't know about STP support for sure, but very much doubt it - this isn't an intended/designed configuration or connection method, and we don't tend to make lives harder for ourselves by implementing features (and then having to test, support and then regression-test on each new software release) if we're not going to utilise the feature.

Sorry,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)