Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] EV1 Linearization via e7 MFD or ST6002

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] EV1 Linearization via e7 MFD or ST6002
08-03-18, 08:35 AM (This post was last modified: 08-03-18 02:22 PM by Chuck - Raymarine - Moderator.)
Post: #9
Thombusc Offline
Junior Member
**
 		Posts: 7
Joined: Jul 2018
Reputation: 0
RE: [CA11] EV1 Linearization via e7 MFD or ST6002
The only thing close to the disk is the ACU. So, I’m pretty sure there is no ferrous interference at the installation location. But, I downloaded a gauss-Tesla app for my phone to check, if I can figure it out. What should I be looking for in terms of interference?

thx
.¤º°`°º¤,¸¸,¤º°`°º¤¤º°`°º¤,
Tom Buscaglia
SV Alera
C&C 37+/40
Vashon Island WA
http://www.sv-alera.com
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] EV1 Linearization via e7 MFD or ST6002 - Thombusc - 08-03-18 08:35 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication