Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Compatibility with older transucers and displays
05-19-19, 11:34 AM (This post was last modified: 05-20-19 12:19 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [DG11] Compatibility with older transucers and displays
Hi Derek,

Thanks for your previous response. Regarding the clutch issue, this turned out to be the drive unit, all now works well.

I do still have an issue with my ST290 displays no longer giving the option for heading displayed since changing to the EV1 autopilot setup.

There is a STng converter in place between the ST290 DPU + all the older transducers and the newer a7d mfd and autopilot.

Do I still need the DPU to support the old transducers and mast displays?

Will the ST290 displays and DPU use the heading data from the EV1 ?

I also currently have an issue with the wind transducer now not being visible or sending data. I have checked the voltages at the pod;
Sheild - red 7.98 V
Sheild - yellow 4.6 V
Sheild - blue. 39.6 mV
Sheild - green 33.3 mV

Does this mean the transducer is done?

Regards,
Russell
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [DG11] Compatibility with older transucers and displays - Russell - 05-19-19 11:34 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)