Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Es mfd remove “no radar” from databar
08-16-18, 05:59 AM (This post was last modified: 09-14-18 10:03 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Es mfd remove “no radar” from databar
I have a 7” es mfd, which is great but needs the display optimising to make the most of the space.
How do I remove the “no radar” icon?
Thanks, peter.
Find all posts by this user
Quote this message in a reply
09-14-18, 10:21 AM
Post: #2
RE: [CA11] Es mfd remove “no radar” from databar
Welcome to the Raymarine Forum Peter,

The Transducer Status bar of the LightHouse II Home screen cannot be customized by the operator. Should the MFD not be interfaced to a radar transducer (radome, open array pedestal), then the Transducer Status icon for Radar will report "No Radar". Similarly, the Transducer Status bar of the LightHouse II Databar cannot be customized by the operator to remove it. Should the MFD not be interfaced to a radar transducer (radome, open array pedestal), then the Radar Transducer Status icon will report "No Radar". The MFD's Databar may be hidden or shown via the command sequence HOME->CUSTOMIZE->DATABAR SET-UP->AUTO-HIDE. When configured ON, the Databar will initially be shown when a page is opened and then will be hidden after approximately five seconds to permit the selected application to fill the entire page/pane.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)