Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] SPX-10 replacement
08-28-18, 11:22 AM (This post was last modified: 08-29-18 02:22 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] SPX-10 replacement
I have a cruiser with the spx-10 autopilot installed. I have a fluxgate fault and the fluxgate ohms checks good. The auto pilot will not turn off and displays a constant fault on the c-series 125 plotter also.

Rather than sending the components in for repair and the cost entailed, I am thinking of upgrading the system instead of attempting to repair the old one.

Would the ev-150 be a good replacement? Can I use the current type-1 hydraulic drive with it? I also have a smartcontroller remote connected, will it work with the ev-150?
Find all posts by this user
Quote this message in a reply
08-29-18, 02:28 PM
Post: #2
RE: [CA11] SPX-10 replacement
Welcome to the Raymarine Forum lkreissl,

Should the vessel feature a Type 1 Hydraulic Pump and a 12VDC power distribution system, then a T70407 EV-150 Corepack (p70Rs autopilot controller, EV1 Sensor Core, ACU150 Actuator Control Unit, and an Evolution autopilot cabling kit) would be recommended.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)