[CA] [CA11] Ray 60 - No position data
|
09-08-18, 10:22 AM
(This post was last modified: 09-12-18 02:02 PM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[CA11] Ray 60 - No position data
Hi,
My Ray60 is showing "No position data" while the position data is available on the STNG network. The satellite icon is blinking in the right upper corner. The GPS signal is recognized in the system test (Setup --> Maintenance --> System test). Other devices (i70s display) are receiving the position without problems. I have seen once that the position was shown on the device, but than it was about half an hour old (because the data/time was also shown). When i take the GPS out of the system and run the test again it is reflected by the test that no GPS is available. My device is a Ray60 HW version MCU-C RF-D SW version: V1.40 Bootloader V2.15 |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] Ray 60 - No position data - bhavers - 09-08-18 10:22 AM
RE: [CA11] Ray 60 - No position data - Chuck - Raymarine - Moderator - 09-12-18, 02:03 PM
RE: [CA11] Ray 60 - No position data - bhavers - 09-17-18, 03:25 PM
RE: [CA11] Ray 60 - No position data - Chuck - Raymarine - Moderator - 09-17-18, 04:01 PM
RE: [CA11] Ray 60 - No position data - bhavers - 09-17-18, 04:37 PM
RE: [CA11] Ray 60 - No position data - bhavers - 10-01-18, 03:45 PM
RE: [CA11] Ray 60 - No position data - Chuck - Raymarine - Moderator - 10-01-18, 03:49 PM
|
User(s) browsing this thread: 1 Guest(s)