The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Selecting units not possible after sw update

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Selecting units not possible after sw update
11-08-18, 08:37 AM (This post was last modified: 11-08-18 09:38 AM by Chuck - Raymarine - Moderator.)
Post: #1
Looma Offline
Junior Member
**
 		Posts: 1
Joined: Nov 2018
Reputation: 0
[CA11] Selecting units not possible after sw update
I have St60+ instruments and ST60 Multi as first instrument. I also have A95 plotter.
I need to meassure dept in meter, and speed in knots and wind in m/s.
After having updated instruments to latest sw, all instruments now shows dept in feet and temperature in F.. When trying to change on A95 I choose meter, but the instrument pop back to feet after some seconds. The same happens on ST60+. I therefore assumed that the ST60 was master and tried on that. However on the User Calibration - the screen with units is newer shown. Should be the screen afger time offset - "temperature" (Units). But that screen newer show.
How do I now get the units changed???

Best Regards,
Mads
S/Y Looma IV
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Selecting units not possible after sw update - Looma - 11-08-18 08:37 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication