Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Link to older forums?
11-22-18, 09:35 AM (This post was last modified: 11-26-18 09:24 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Link to older forums?
Hello:

Does anyone have a link - or access to - the older forums?

I am looking in particular for a post I created about September 2015 where I used a Maretron "Micro Field-Attachable Connector - Male - FA-CM-ST" to bridge between STNG and N2K networks. My recollection was that I whacked an end off a STNG backbone and attached this connector - I'm pretty sure I took a photo of the Maretron documentation with the STNG wires identified.

It worked a peach on my previous vessel and now I need to replicate on my new one.

Regards,
Keith

Lulu: 36' Little Harbor WhisperJet
Raymarine: Axiom 12 RV, RV200, Axiom 12 Pro, Evo 1/ACU 150/P70RS, Quantum Q24C, HS5
---previous----
Refugio: 44' trawler
Raymarine: ACU-400, EV-1, P70R, a78, M81105 RFU, ST60 RAI, E22158 ST-STNG
NMEA 2000: Garmin 740S & GMR18 HD, Airmar WS-200WX, Actisense NGT-1
Find all posts by this user
Quote this message in a reply
11-26-18, 09:39 AM
Post: #2
RE: [CA11] Link to older forums?
Welcome back to the Raymarine Forum Keith,

Please click here to view a FAQ addressing the retirement of the old Raymarine Technical Community Forum.

Please click here to view a FAQ addressing the subject of connecting a SeaTalkng Backbone Cable to a third party NMEA 2000 backbone cable.
Find all posts by this user
Quote this message in a reply
11-29-18, 09:37 PM (This post was last modified: 11-30-18 09:04 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] Link to older forums?
Thank you Chuck - that 2nd link will help with the pin connections. In my prior installation I power isolated the two backbones, that link referred to a single power at the midpoint - is that preferred?

Lulu: 36' Little Harbor WhisperJet
Raymarine: Axiom 12 RV, RV200, Axiom 12 Pro, Evo 1/ACU 150/P70RS, Quantum Q24C, HS5
---previous----
Refugio: 44' trawler
Raymarine: ACU-400, EV-1, P70R, a78, M81105 RFU, ST60 RAI, E22158 ST-STNG
NMEA 2000: Garmin 740S & GMR18 HD, Airmar WS-200WX, Actisense NGT-1
Find all posts by this user
Quote this message in a reply
11-30-18, 09:05 AM (This post was last modified: 11-30-18 09:07 AM by Chuck - Raymarine - Moderator.)
Post: #4
RE: [CA11] Link to older forums?
Keith,

Q. In my prior installation I power isolated the two backbones, that link referred to a single power at the midpoint - is that preferred?
A. Yes. Please note that the ACU-400 is capable of supplying power to a backbone. It is considered to be a best installation practice to use a dedicated, switched 12VDC power circuit to power to the backbone rather than to use an ACU or autopilot course computer to do so.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)