Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Segmentation of the seatalkng network
12-04-18, 11:28 AM
Post: #2
RE: [CA11] Segmentation of the seatalkng network
Welcome to the Raymarine Forum mm,

As a best installation practice the SeaTalkng / NMEA 2000 backbone will not be powered via an autopilot course computer / ACU or from a SeaTalk bus. Instead, the SeaTalk / NMEA 2000 backbone will be powered via a spur socket which is located at the approximate midpoint of the backbone's LEN load. A SeaTalkng Power Cable will be connected to a switched 12VDC power circuit which in turn has been protected with a 3A fuse or 5A breaker. Should the system feature devices having a SeaTalk (not to be confused with SeaTalkng) communications interface, then these devices will be interfaced to an unpowered SeaTalk bus which will be instead powered via a SeaTalk to SeaTalkng Converter(s) which has been installed as a component of the backbone.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Segmentation of the seatalkng network - Chuck - Raymarine - Moderator - 12-04-18 11:28 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us