[CA] [CA11] Autopilot Integration to Seatalkng
|
01-22-19, 01:25 PM
Post: #4
|
|||
|
|||
RE: [CA11] Autopilot Integration to Seatalkng
Redman,
Q. So I will need to integrate the ST6001 into the STng network by connecting a ST1 to bare-end cable (D229) to the Seatalk B terminal of the S2 Autopilot, then utilize the D244 connecting block to connect that cable to the ST-STng converter? A. Not quite correct. The ST6001 will be connected to the SeaTalk A port of the S2 autopilot course computer via a ST1 to bare-end cable. As you have suggested, the SeaTalk to SeaTalkng Converter Cable supplied with the SeaTalk to SeaTalkng Converter Kit will be connected to the SeaTalk (yellow) socket of the SeaTalkng Converter and to a D244 SeaTalk Junction Block. The SeaTalk Junction Block will then be connected to the SeaTalk B port of the S2 autopilot course computer via a ST1 to bare-end cable. When connecting the latter cable to the SeaTalk B port of the S2 autopilot course computer, the red lead of this cable will not be used and should be insulated to prevent shorting. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)