Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
A128 Transducer Question
05-06-16, 03:55 PM (This post was last modified: 05-06-16 03:56 PM by Chuck - Raymarine - Moderator.)
Post: #11
RE: A128 Transducer Question
Thank you Chuck for your feedback, have a great weekend.
Find all posts by this user
Quote this message in a reply
05-06-16, 03:57 PM
Post: #12
RE: A128 Transducer Question
You're welcome.
Find all posts by this user
Quote this message in a reply
05-07-16, 12:04 PM
Post: #13
RE: A128 Transducer Question
While searching for a good location in my stern bilge area to install my CPT 120 I realize that it will be in close proximity to my existing Airmar transducer connected to my DSM 300. Is there a distance I should keep between the CPT 120 and the existing Airmar inhull devise?
I am concern about cross talk interference, does the dsm 300 w/ transducer run on a different frequency then the A128 chirp downvision unit?

Thank you, Scott
Find all posts by this user
Quote this message in a reply
05-09-16, 10:07 AM
Post: #14
RE: A128 Transducer Question
Scott,

Raymarine has not specified a minimum installation distance from other transducers. For thru-hulls installed on vessels equipped with twin screws, a transducer is commonly installed on each side of the keel. Interference noise between CHIRP and common 50/200 kHz fishfinder transducers installed on the same vessel is typically quite minimal.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)