Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom 9 RV Sounder issues
04-09-19, 12:36 PM (This post was last modified: 04-09-19 12:46 PM by Chuck - Raymarine - Moderator.)
Post: #20
RE: [CA11] Axiom 9 RV Sounder issues
ktcarter,

Like transducer beam for DownVision the transducer beam for SideVision has a very small fore-aft component. The mirroring of the SideVision imaging may be indicative of transducer signal being reflected off of a hard surface (ex. outdrive, lower unit, or hull structure). I see similar mirroring when my lower unit is lowered into the beam of my boat's SideVision transducer. Accordingly, searching for bottom structures, I will raise my drive unit until the mirroring disappears. The imaging otherwise appears normal except for the stoppage shown within the last video. I would not have expected the system to stop plotting SideVision because the system lost bottom depth. Is it possible that you have configured Sonar or DownVision for a manually set range rather than auto range?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Axiom 9 RV Sounder issues - Chuck - Raymarine - Moderator - 04-09-19 12:36 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)