[CA] [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD?
|
02-16-19, 08:03 PM
(This post was last modified: 02-19-19 10:29 AM by Chuck - Raymarine - Moderator.)
Post: #6
|
|||
|
|||
RE: [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD?
Kevin
If you're considering the Mercury Gateway, I found it worked without a hitch to tie my twin QSB 5.9's to my e165 LH2 system. It was a simple matter to plug the gateway into a spare port on one of the Smartcraft junction boxes and the other end into an open STNG spur socket using a Raymarine devicenet adapter cable. All of the data came up immediately for both engines with no configuration or setup required on the MFD other than to pick the individual data items to display. Could not have been easier. Jim |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD? - polingk - 02-13-19, 01:55 PM
RE: [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD? - Chuck - Raymarine - Moderator - 02-13-19, 02:10 PM
RE: [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD? - polingk - 02-14-19, 05:10 PM
RE: [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD? - jwasko - 02-16-19 08:03 PM
RE: [CA11] Use the ECI-100 Engine and Control Interface with our GS Series MFD? - polingk - 02-22-19, 06:13 PM
RE: [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD? - Chuck - Raymarine - Moderator - 02-15-19, 09:55 AM
RE: [CA11] Use the ECI-100 Universal Engine and Control Interface with our GS Series MFD? - polingk - 02-15-19, 06:10 PM
|
User(s) browsing this thread: 1 Guest(s)