[CA] [CA11] Configure New Network and Incorporate S2 Course Computer

[ventus]

Almost there....

For the VHF to AIS700 connection, do I really need the E70196 converter? I have an Icon IC-M422 VHF. It has NMEA IN and NMEA OUT leads on it. I noticed on the AIS700 that its power cable has NMEA 0183 Hi and Low Outputs and Inputs. Could I just connect that cable to the VHF? If so do I use Hi or Low?

If not and I need to use the converter kit as shown in my latest diagram, I assume all of those wires on the power cable (with exception of the power cable) are just insulated ends not connected to anything. Then the backbone cable delivers the position data to the converter which is then delivered to the VHF radio. Correct?


Lastly, I forgot to add in an RMK-10 to the diagram. I want to install it next to the Axiom 9 at the helm to only control that MFD. I noticed in the box today that it looks like it connects via a Raynet to Raynet cable. Since I already have a 30' Raynet to Raynet cable going out of that MFD to the other MFD how can I connect this RMK-10 to this display? I don't want to control the Axiom 7 with it, only the Axiom 9 it will be next to. I first assumed the only way to do this would be to get another 30' Raynet to Raynet cable and run both to the Nav station where a HS5 switch would go, but I'd rather not get into all of that if I dont have to. Also, how is the RMK-10 powered, from the network connection only or do I need to use the additional power inlet?

Thank you!