Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Configure New Network and Incorporate S2 Course Computer
07-08-19, 11:00 AM
Post: #21
RE: [CA11] Configure New Network and Incorporate S2 Course Computer
Hi Chuck,

I have finally received my MMSI number and have successfully finalized my AIS transponder. I am still having an issue connecting the E70196 to my VHF to receive Lat Lon info. My E70196 has a flashing light on it and data is indeed being transmitted through it since it is part of my backbone and all is working fine. I connected the yellow wire with the positive end to the red NMEA 0183 input wire on my VHF and the negative wire to the negative VHF wire since my VHF unit does not have a dedicated negative wire as you instructed.

No GPS data showing on my VHF and it says NO LOCATION in its display. I tried restarting all electronics and that had no effect. Maybe my VHF unit is not compatible with this? Though it has the NMEA 0183 input wire. Any ideas?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Configure New Network and Incorporate S2 Course Computer - ventus - 07-08-19 11:00 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)