Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Color bleed on C120 screen
03-21-19, 08:19 PM (This post was last modified: 03-25-19 11:55 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG11] Color bleed on C120 screen
When I update my C120 to v.5.16 I get color bleed on the screen in several places. If I go back to using v.4.30 the color bleed goes way. Is there a way around this?
Find all posts by this user
Quote this message in a reply
03-25-19, 12:00 PM
Post: #2
RE: [DG11] Color bleed on C120 screen
Hi Max Bottomtime

Thank you for your enquiry

We are not aware of any issues with the update to 5.16, this software has been in the field for many years and no reports of this issue have been received prior.

We would recommend you carry out a full factory reset after the software update, as per the below . . .

* With the unit turned off press and hold the left hand soft key
* Keep it pressed and turn the unit on
* On screen it will say 'Factory Reset' and count down from 3
* Unit will reset and load into normal operation. This can take a couple of extra minutes than normal.

**Please make sure you back up all Waypoints and Routes etc to a separate Compact Flash Card other than your Cartography Card**

Otherwise there must be a mechanical flaw in the C120 itself

Thanks
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)