Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] eS98 to networking switch
04-14-19, 07:26 PM (This post was last modified: 04-17-19 03:56 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] eS98 to networking switch
This winter I added a Backbone and Networking switch. I'm having difficulty connecting the switch to my eS98. What cable is used from the switch and where on the back of the eS do I connect?
Find all posts by this user
Quote this message in a reply
04-17-19, 03:56 PM
Post: #2
RE: [CA11] eS98 to networking switch
Welcome to the Raymarine Forum Seahorse,

What model of network switch did you install?
Visit this user's website Find all posts by this user
Quote this message in a reply
04-19-19, 05:45 PM (This post was last modified: 04-22-19 12:42 PM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] eS98 to networking switch
HS5. The book says to use a e series A06061. It does not plug into anything I own.

What did I order wrong
Find all posts by this user
Quote this message in a reply
04-22-19, 12:48 PM
Post: #4
RE: [CA11] eS98 to networking switch
Seahorse,

The A06061 E-Series to Seatalk Adapter Cable is designed to support interfacing an E-Series Classic MFD's (E80, E120) SeaTalk2/NMEA 2000 port to a spur socket within a system's powered and properly terminated SeaTalkng / NMEA 2000 backbone ... this adapter is not applicable to eS-Series MFDs. Instead, an appropriate length of RayNet (F) to RayNet (F) Cable would be used to interface one of the Ethernet Network sockets of the eS-Series MFD to one of the Ethernet Network sockets of the HS5 RayNet Network Switch.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us