Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] SP-X10 calibration
04-27-19, 01:54 AM (This post was last modified: 04-29-19 12:26 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] SP-X10 calibration
Hi, I have a used SP-X10 with an ST-6002 control head. I installed it and went through the calibration process (several times). Each time I turn the power off I get a message on the control head "Required Calibrn". I set the boat type to Sail Boat. I also did a "swing" and have a deviation of 9 degrees. Why does it still display Required Calibration?
Find all posts by this user
Quote this message in a reply
04-29-19, 12:31 PM
Post: #2
RE: [CA11] SP-X10 calibration
Welcome to the Raymarine Forum Phillip,

Did you also perform the AutoLearn feature of the SeaTrial calibration (see page 16 of the SPX-10 Set-up and Commissioning Guide? If so and the problem persists, then it would indicate that the autopilot course computer is suffering a memory failure and should be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)