Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Replace E120 Classic with ES127 MFD Cutout
05-15-16, 07:08 PM
Post: #1
Replace E120 Classic with ES127 MFD Cutout
I'm planning an electronics upgrade. I currently have a e120 classic flush mounted in the helm. I want to replace it with an eS127. How does the cutout for the two MFDs differ? I hope I can fit the new eS127 in the old e120 cutout, or just enlarge it a bit?

Thank you,
Bob
Find all posts by this user
Quote this message in a reply
05-16-16, 01:10 PM (This post was last modified: 05-16-16 01:12 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Replace E120 Classic with ES127 MFD Cutout
Welcome to the Raymarine Forum Bob,

The surface mount cut-out of the E-Series Classic MFDs differ from those of the eS-Series MFDs. The surface mount templates are shown below. These same templates may be downloaded via Product Documentation web page.

[Image: attachment.php?aid=239]

[Image: attachment.php?aid=240]


Attached File(s) Thumbnail(s)
       
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)