[TG] [TG11] Flir m132 -clear cruise feature
|
05-27-19, 10:02 PM
(This post was last modified: 05-29-19 09:32 AM by Chuck - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
RE: [TG11] Flir M132 - Clear Cruise feature, ranges show as 0
Hello rltrbill,
I've seen this when the camera mounting height wasn't set up. Try going into Menu > Setup > Camera Motion > Camera height above waterline and changing the current height calibration slightly. Even if the current value is correct, try changing this 0.1 foot/metre then back again, just to make sure that that setting is saved. If that doesn't solve the problem, and the display's running v3.9.46 software, come back to me. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)