Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Axiom power on reset
05-23-19, 04:16 PM (This post was last modified: 05-24-19 12:39 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Axiom power on reset
I have an Axion Pro 9ā€ and 12ā€ and I want to preform a Power On reset. Following the instructions you posted on another thread, should I power on only the 12ā€ data master per the sequence listed or both Axiom Pro's together? Do I need to preform the Power on reset to each unit or only the data master?
Thanks
John
Find all posts by this user
Quote this message in a reply
05-24-19, 12:44 PM
Post: #2
RE: [CA11] Axiom power on reset
Welcome to the Raymarine Forum John,

As I believe that we discussed during a phone conversation, it would be recommended that:
- both MFDs be switched ON
- that the repeater MFD be switched OFF,
- that the power ON reset then be performed to the Data Master MFD
- that the startup wizard on the Data Master be completed
- that the Data Master MFD be switched OFF
- that the repeater MFD be switched ON and permitted to complete startup initialization
- that the owner ON reset then be performed to the repeater MFD
- that the Data Master MFD be switched ON
- that the correct MFD be designated as the Data Master (i.e. the system will prompt you to choose a Data Master)
Visit this user's website Find all posts by this user
Quote this message in a reply
05-29-19, 08:37 PM
Post: #3
RE: [CA11] Axiom power on reset
Chuck,
I preformed the factory resets as we discussed. They worked as expected but did not correct the 3D transducer issue.
Iā€™m curious to know if you asked about a heading sensor in the transducer vs motion sensors?

Thanks,
John
Find all posts by this user
Quote this message in a reply
05-30-19, 10:08 AM
Post: #4
RE: [CA11] Axiom power on reset
John,

Indeed, the AHRS within the RealVision transducers is a magnetic north seeking device. After calibration (I typically recommend that a couple of slowly executed figure 8's be performed to calibrate the AHRS), should the imaging be skewed as you have reported, then it would appear the transducer's proximity to the diesel engines is exposing them to a level of deviation which the system cannot compensate for. In such cases, it would be recommended that the AHRS Stabilization configuration setting be configured OFF.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us