Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] AIS 650 stops displaying targets
06-12-19, 01:16 AM
Post: #4
RE: [TG11] AIS 650 stops displaying targets
Hello Tim,

The only other thing I can think to suggest at the moment is that you record some of the NMEA2000 traffic during an instance of the problem, to see whether it's communicating at all. We can read the log for you if you send it in.

Other than that, the failure of the AIS to be correctly detected over USB at the time the problem occurs suggests an internal fault, if it's not a supply problem - remembering that supply reaching the AIS may be a lot lower than at the batteries or distribution panel.

One other possibility - it could conceivably be a grounding problem, if either the Standard Horizon or the PC (PC's power supply from an invertor?) weren't isolated.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] AIS 650 stops displaying targets - Tom - Raymarine - Moderator - 06-12-19 01:16 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)