Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST60 Wind Display
05-17-16, 10:02 PM (This post was last modified: 05-18-16 12:35 PM by Steve - Raymarine - Moderator.)
Post: #1
ST60 Wind Display
Purchased this unit used (in Box) a couple of years ago, it was opened but never installed. When I finally installed the control head to my network via seatalk, as well as connecting all the cables as per the manual, the unit display is making a loud buzzing noise. None of the keys work nor do the back lights, the wind direction needle does not move and the wind speed indicator is blank. I am having a hard time finding a replacement display.

could this be a 12 volt power supply issue?

thanks in advance
Find all posts by this user
Quote this message in a reply
05-18-16, 12:33 PM (This post was last modified: 05-18-16 12:34 PM by Steve - Raymarine - Moderator.)
Post: #2
RE: ST60 Wind Display
First, do you have the masthead transducer connected directly to the ST60 Wind display? It could be a voltage issue, if you measure the Red and Gray on Seatalk you should be seeing 12+ VDC.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)