Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] adjust rudder stop angle
06-09-19, 02:21 PM (This post was last modified: 06-10-19 07:24 AM by Louise - Raymarine - Moderator.)
Post: #1
[LW11] adjust rudder stop angle
Hi !

I have just started uo my EV 200 linear system. It seems to be working fine but only tried it in calm conditions.

My rudder stops are a bit to weak for the drive- they bend slightly during the dock side calibration, is it possible to enter the rudder stop angle manually to decrease it a few degrees in order to make it stop sooner? I have a working rudder position sensor, EV-1 ACU 200, Linear drive type 1.

Best Regards

Peter
Find all posts by this user
Quote this message in a reply
06-11-19, 11:00 AM
Post: #2
RE: [LW11] adjust rudder stop angle
Dear Peter,

You need to set the rudder limits up on the EV200. You can find the instructions here.

Many Thanks
Louise
Find all posts by this user
Quote this message in a reply
06-17-19, 07:41 AM
Post: #3
RE: [LW11] adjust rudder stop angle
Thank you, it went quite easy with your support. You might have linked to a different doc. than the applicable one but i found in the Swedish version.

Best Regards and thanks for the support.

Peter
Find all posts by this user
Quote this message in a reply
06-20-19, 10:51 AM
Post: #4
RE: [LW11] adjust rudder stop angle
You are welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)