Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG11] AIS700 always heading north
06-12-19, 08:10 AM (This post was last modified: 06-13-19 04:54 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG11] AIS700 always heading north
I have an AIS700 installed, without a plotter. Other ships see me on their plotter always heading north, while I am sailing other directions. Example: I was sailing at a course of 220, while other see my vector facing north (see attached image: I am sailing towards the harbour!)

Other instruments that are connected in the network: I70S Tridata+wind, including 2x MFD I70. Other than the AIS700 and it's components there are no additional GPS of electronic Compass installed.

The dealer says this is impossible and therefore cannot be fixed.

Hope someone knows the cause and solution to this issue.

Kind regards,

Anton


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
06-13-19, 05:01 AM
Post: #2
RE: [DG11] AIS700 always heading north
Hi Anton,

Thank you for your enquiry.

The heading of the AIS target/ Icon is derived from the COG of the GPS attached directly to the AIS700 box. You should connect a laptop with the PROAIS2 that was supplied with the AIS700 to the AIS700 and check the diagnostics, make sure all the GPS data is correct and that the COG from the direct connect GPS is correct.
If you are unsure, please forward a photograph of the screens of the laptop when PRO AIS2 is running.

Regards

Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us