Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] S100 basestation to Seatalkng
06-14-19, 06:45 AM (This post was last modified: 06-17-19 08:57 AM by Derek - Raymarine - Moderator.)
Post: #1
[DG11] S100 basestation to Seatalkng
Hi,
I recently bought an EV-100 autoilot kit and have alreadi installed it in the boat with the included Seatalkng (network or backbone). Earlier I had baught a S100 remote - but never put into use.
The S100 came with a spur to connect to the older Seatalk (which I dont have). My question is then: Do I need to buy a converter for Seatalk/Setalkng or would it be enough to buy a spur for the Seatalkng to replace the other one ?

Thanks,
Bjarni
Find all posts by this user
Quote this message in a reply
06-17-19, 09:00 AM
Post: #2
RE: [DG11] S100 basestation to Seatalkng
Hi Bjarni,
Thank you for your enquiry.

The S100 is a SeaTalk device - using the earlier SeaTalk data protocol, the EVolution autopilot uses the current STng data protocol and the two are not compatible.

However, if you connect the S100 base station SeaTalk to a SeaTalk to STng converter, E22158, then the converter will be connected to the STng backbone and will enable the S100 to operate with the EVolution autopilot.

Regards

Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)