[CA] [CA11] Quantum — Quantum 2

[E.hatch2086@cox.net]

Returned on cruise today,yesterday prior to leaving on return did a factory reset then tried radar at dock ok. This morning started engine with dock power connected then unplugged dock power and tried to start radar no luck after a few tries started genset . Kept trying to connect radar using on button on Axiom and the radar power switch no luck. After about 10 min of trying decided to leave dock and start return. Continued trying to get radar connected voltage on power feed to Axiom and radar was showing 14.1 volts. Checked network page and it only showed Axiom and radar wire adapter. Finally was to connect radar. After about 30 min radar by itself jumped to standby (no image,but transmit button on screen) so hit and image came back. Then about 2 hrs into return while going straight radar image sort of rotated and got a little garbled for a sec.
Then at 2 hrs 45 min lost radar image. About 1 mile from home. Kept trying to get it back no luck. Got to dock left engine running,left genset running, did not connect shore power. Got boat settled then went to bridge to try radar it connected and I hit transmit and image came back. Then shut engine and genset down,connected to shore power. Left radarvon for about 3 hrs. Then shut it down and at dome disconnected power and measured voltage of 13.77 then measured it at output of the Dc stabilizer which feeds the radar same reading 13.77. Note at same time voltage going into stabilizer was 13.29. Reconnected power to dome and started radar up it connected to Axiom. The mystery and frustration continues.