Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] COntrol of Evolution EV200 from e97/e127
08-15-19, 07:23 PM (This post was last modified: 08-21-19 10:11 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] COntrol of Evolution EV200 from e97/e127
My Evolution is installed and dockside wizard completed. Sea trail to set sensor is this weekend. Can I control this from the MFD? Also, once I bring up a track or route on the MFD, and I press “follow route/track” Does the pilot take over automatically?

Thank you
Find all posts by this user
Quote this message in a reply
08-21-19, 10:20 AM (This post was last modified: 08-21-19 10:21 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] COntrol of Evolution EV200 from e97/e127
Welcome back to the Raymarine Forum Tony,

Q1. Can I control this (autopilot) from the MFD?
A1. Yes. You will need to enable the LightHouse II Autopilot Controls feature (HOME->SET-UP->SYSTEM SETTINGS->EXTERNAL DEVICES->PILOT SET-UP->PILOT CONTROL) and Pilot bar feature (HOME->SET-UP->SYSTEM SETTINGS->EXTERNAL DEVICES->PILOT SET-UP->PILOT BAR). Detailed information on this subject may be found within Chapter 7: Autopilot control of the LightHouse II Release 19 Operating Instructions.

Q2. Once I bring up a track or route on the MFD, and I press “follow route/track” Does the pilot take over automatically?
A2. Yes. Onscreen prompts will be displayed.
Find all posts by this user
Quote this message in a reply
08-21-19, 06:36 PM (This post was last modified: 08-22-19 08:00 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA11] COntrol of Evolution EV200 from e97/e127
It appears that the link has changed locations?
Find all posts by this user
Quote this message in a reply
08-22-19, 08:01 AM
Post: #4
RE: [CA11] COntrol of Evolution EV200 from e97/e127
Tony,

I tested the link to the LightHouse II Advanced Operations Guide within my last post and it does indeed open this document within Box.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)