Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Autopilot clutch releasing
07-31-19, 08:13 AM (This post was last modified: 08-02-19 02:36 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Autopilot clutch releasing
I have been having trouble with the clutch arm releasing while in autopilot mode. The old FAQ related to the arm releasing says:
1) the vessel should be located dockside, on the mooring, or at anchor
2) on the back side of the drive loosen the belt tensioner's allen head locking bolt enough that the square belt tension knob may be rotated
3) tighten the square belt tension knob until the tension begins to be felt half way through the rotation of the clutch lever's range of motion
4) tighten the belt tensioner's allen head locking bolt

Does #3 mean tension is felt in the tension knob or tension is felt in the wheel movement?
Find all posts by this user
Quote this message in a reply
08-02-19, 02:39 PM
Post: #2
RE: [CA11] Autopilot clutch releasing
Welcome back to the Raymarine Forum daknecht,

As indicated within the instructions referenced, the tension being referred to is being sensed via clutch lever.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)