Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Down loading routes via Wi-Fi
08-04-19, 06:47 AM (This post was last modified: 08-06-19 01:48 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] Down loading routes via Wi-Fi
Looking for instructions or tutorial that describes loading routes via Wi-Fi. The MFD I have is an Axiom 9 running Navionics+
Find all posts by this user
Quote this message in a reply
08-06-19, 01:56 PM
Post: #2
RE: [CA11] Down loading routes via Wi-Fi
Welcome to the Raymarine Forum Steve,

If operating with LightHouse 3 v3.8.x and earlier versions of LH3 software supporting waypoint/route synchronization, then the FAQ providing the procedure may be found here. LightHouse 3 v3.9.x software featured a defect within the Navionics software libraries which would have prevented this feature from being used. With the introduction of LightHouse 3.10.x and later software waypoint/route synchronization is seamless MFDs which have been connected via WiFi to a mobile devices running the latest version of the Navionics Boating app. To further clarify "seamless", as waypoints and routes are created within the Navionics Boating app and/or when synchronization is commanded via the Navionics Boating app, the corresponding waypoints and routes will be added the MFD's waypoint and route lists without need to perform any actions via the MFD.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)