Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] C-80 COG after Factory reset
08-23-19, 10:47 AM (This post was last modified: 08-26-19 03:39 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] C-80 COG after Factory reset
I accidentally did a factory reset on m Classic C-80. I have been able to get every thing set back up the way I had it previously to the reset except that it is not displaying a Course Over Ground now. If I engage the auto pilot and "Go Too" the curser it will track correctly and display the course over ground in the display bar, but will not show the green COG indicating line on the display. When the auto pilot is disengaged it does not show any COG info. Everything worked great until I hit the factory reset and I have gone through everything in the menu over and over and I can't figure out what setting is not right. Can you Help?
Thanks, Doug
Find all posts by this user
Quote this message in a reply
08-26-19, 03:42 PM
Post: #2
RE: [CA11] C-80 COG after Factory reset
Welcome to the Raymarine Forum Doug,

The COG vector may be configured ON/OFF via the command sequence DATA->CHART VECTORS->COG VECTOR. Vector length may be configured via the command sequence MENU->CHART SET-UP->VECTOR LENGTH.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)